Rebalancing the Pulley
03/16/14 22:52 Filed in: All
I did my best to rebalance the pulley. It really didn't seem that far off. I made a holder plate and a filament hanger. There was a slight offset that was corrected by a little milling. This setup is not precise enough to go much farther.
The locations that needed milling were on the side opposite the holes that had been drilled. This kind of makes sense if the holes were drilled to compensate for differences in the mass of the bosses that were milled off.
The locations that needed milling were on the side opposite the holes that had been drilled. This kind of makes sense if the holes were drilled to compensate for differences in the mass of the bosses that were milled off.